Juniper PTX10001-36MR - Page 27

PTX10001-36MR Chassis Status LEDs
The PTX10001-36MR has three LEDs that indicate system status. They are located in the middle of the
management panel (see Figure 7 on page 17).
Table 7 on page 18 describes the chassis status LEDs on a PTX10001-36MR, their colors and states,
and the status that they indicate.
Table 7: Chassis Status LEDs on a PTX10001-36MR Device
Name Color State Descripon
ONLINE Unlit O The device is powered o.
Green On steadily Junos OS Evolved is loaded on the
device.
Green Blinking Junos OS Evolved is being loaded on
the device.
ALM (Alarm) Unlit O The device is halted or there is no
alarm.
Red On steadily A major hardware fault has occurred,
such as a temperature alarm or
power failure, and the device has
halted. Power o the device by
seng the AC power source outlet
to the OFF (O) posion, or
unplugging the AC power cords.
Correct any voltage or site
temperature issues, and allow the
device to cool down. Power on the
device and monitor the power
supply and fan LEDs to help
determine where the error is
occurring.
18