Keithley 2701

List of Tables
1 Getting Started
Table 1-1 Model 77xx series switching modules.................................... 1-9
Table 1-2 Fuse ratings........................................................................... 1-18
Table 1-3 Display commands................................................................ 1-21
Table 1-4 Default settings ..................................................................... 1-24
Table 1-5 Default setup commands....................................................... 1-27
Table 1-6 Exercise 1—Measure AC volts - store readings in buffer..... 1-31
Table 1-7 Exercise 2 — Close and open channels (system
channel operation) ............................................................ 1-35
Table 1-8 Exercise 3 — Simple scanning ............................................. 1-38
2 Closing and Opening Switching Module Channels
Table 2-1 System channel control commands....................................... 2-13
Table 2-2 Multiple channel control commands..................................... 2-20
Table 2-3 Relay closure count commands ............................................ 2-34
3 Basic DMM Operation
Table 3-1 Autozero and LSYNC commands .......................................... 3-6
Table 3-2 Color codes — thermocouple wires...................................... 3-40
Table 3-3 Thermistor temperature measurement configuration............ 3-43
Table 3-4 Thermocouple temperature measurement configuration ...... 3-43
Table 3-5 RTD parameters .................................................................... 3-44
Table 3-6 4-wire RTD temperature measurement configuration .......... 3-44
Table 3-7 Basic measurement commands............................................. 3-51
4 Range, Digits, Rate, Bandwidth, and Filter
Table 4-1 Measurement ranges and maximum readings......................... 4-2
Table 4-2 Range commands.................................................................... 4-4
Table 4-3 Digits commands .................................................................... 4-7
Table 4-4 Rate and bandwidth settings ................................................... 4-9
Table 4-5 Rate and bandwidth commands ............................................ 4-11
Table 4-6 Filter commands ................................................................... 4-20
5 Relative, Math, Ratio, Channel Average, and dB
Table 5-1 Rel commands ........................................................................ 5-4
Table 5-2 Math commands.................................................................... 5-12
Table 5-3 Ratio and channel average commands.................................. 5-18
Table 5-4 dB commands ....................................................................... 5-21