Model 2701 User’s Manual SCPI Reference Tables 15-23
SYSTem
:BOARd PC board:
:SNUMber? Acquire serial number of PC board.
:REVision? Acquire revision level of PC board.
:BATTery Battery:
:PRESent? Is a battery installed?; 0 = no, 1 = yes.
:STATus? Returns “OK”, “MEMORY LOST”, or
“CHARGING FAILURE”. Memory is lost
when the battery is not installed and upon
a reset after a firmware upgrade. A
charging failure occurs when it is time for a
new battery.
:PASSword Password:
:ENABle <b> Enables or disables the use of password.
:ENABle? Query password use.
:CDISable <password> Disables protected commands.
[:CENable] <password> Enables protected commands.
:STATe <b> Returns “0” if password protected
commands are disabled. Returns 1 if
enabled.
:NEW <password> Set new password.
:COMMunicate Ethernet and RS-232 commands:
:SELect <name> Select communications mode; ETHernet or
SERial.
:ETHernet Ethernet:
:ADDRess <value> Set IP address of 2701; “n.n.n.n”.
:ADDRess? Query IP address of 2701.
:MASK <value> Sets the subnet mask; “n.n.n.n”.
:MASK? Query subnet mask.
:GATeway <value> Set the Ethernet gateway; “n.n.n.n”.
:GATeway? Query the Ethernet gateway.
:DHCP <b> Enable or disable Dynamic Host Control
Protocol (DHCP).
Table 15-7 (continued)
SYSTem command summary
Command Description
Default
parameter Ref SCPI
To Next Page
Loading...
Need help?
General
