Keysight B2961A/B2962A User’s Guide, Edition 3 4-27
Front Panel Reference
Config key group
Config key group
Pressing the Config key displays the following softkeys for setting several functions
of the channel.
Source Displays the following softkeys for setting the source operation.
Connection Channel operation and connection setup. See “Output
Connection dialog box” on page 4-28.
Filter Output filter setup. See “Output Filter dialog box” on page
4-29.
Ext. Filter External filter setup. See “External Filter dialog box” on page
4-29.
Sweep Sweep source detail setup. See “Sweep dialog box” on page
4-30.
Output R Programmable output resistance (using Emulation Table) setup.
See “Output R (Emulation) dialog box” on page 4-31.
Measure Displays the following softkey for setting the measurement operation.
R Compen Resistance compensation ON or OFF. See “Resistance
Compensation” on page 6-18.
On a 1-channel model, pressing this key displays the ON and
OFF keys used to set the resistance compensation on or off.
On a 2-channel model, pressing this key displays the ALL, Ch
1, and Ch 2 keys. They are used to specify the channel for
setting the resistance compensation on or off.
ALL specifies channels 1 and 2.
Ch 1 specifies channel 1 only.
Ch 2 specifies channel 2 only.
Common Displays the following softkeys for setting the miscellaneous function.
Wait Source and measurement wait time setup. See “Wait Control
dialog box” on page 4-31.
To Next Page
Loading...
Need help?
General
