Keysight B2961A/B2962A User’s Guide, Edition 3 5-25
Front Panel Operations
To Execute Measurement
The Wait Control dialog box opens.
2. Set each parameter in the Measure column.
3. To apply the settings, press Apply.
To apply the settings and close the dialog box, press OK.
To cancel the setting change, press the Cancel/Local key.
To Enable or Disable Resistance Compensation
1. Press the Config > Measure > R Compen function keys.
2. For the 2-channel models, specify the channel to which the setting change is
applied by using the following function keys.
ALL: Channels 1 and 2 (Ch 1 and Ch 2)
Ch 1: Channel 1 (Ch 1) only
Ch 2: Channel 2 (Ch 2) only
3. To enable the resistance compensation, press ON.
To disable it, press OFF.
To cancel the setting change, press the Cancel/Local key.
To Next Page
Loading...
