Keysight Technologies B2961A - Function Parameters

Keysight B2961A/B2962A User’s Guide, Edition 3 4-13
Front Panel Reference
Display and Assist Keys
Function Parameters
The following setup parameters are available.
Function: Output function. The following parameters are available.
OFF: DC output
LINEAR SINGLE: Linear single sweep output
LINEAR DOUBLE: Linear double sweep output
LOG SINGLE: Log single sweep output
LOG DOUBLE: Log double sweep output
LIST: List sweep output
ARB EXPONENT: Exponential waveform output
ARB RAMP: Ramp waveform output
ARB SINUSOID: Sinusoidal waveform output
ARB SQUARE: Square waveform output
ARB TRAPEZOID: Trapezoidal waveform output
ARB TRIANGLE: Triangle waveform output
ARB USER: User defined arbitrary waveform output
For details, see “Sweep Output” on page 6-9, “List Sweep”
on page 6-10, and “Arbitrary Waveform Output” on page
6-11.
Start: Start value of sweep source or arbitrary waveform.
Stop: Stop value of sweep source.
Points: Number of sweep source steps.
Step: Step value of sweep source.
End: End value of arbitrary waveform.
Delay: Delay time of arbitrary waveform.