5-22 Keysight B2961A/B2962A User’s Guide, Edition 3
Front Panel Operations
To Execute Measurement
To Execute Measurement
This section describes the following measurement operations.
• “To Set Measurement Mode”
• “To Perform Spot Measurement”
• “To Stop Measurement”
• “To Set Measurement Time”
• “To Perform Sweep Measurement”
• “To Set Measurement Trigger Parameters”
• “To Set Measurement Wait Time”
• “To Enable or Disable Resistance Compensation”
To Set Measurement Mode
1. For the Single view, press the Measure assist key. For the Dual view, press the
Ch1 Measure or Ch2 Measure assist key.
2. Press AMPS (I) for the current measurement, VOLTS (V) for the voltage
measurement, OHMS (R) for the resistance measurement, WATTS (P) for the
power measurement, or %LIMIT (%) for the percent-to-Limit measurement.
To Perform Spot Measurement
1. Set the measurement mode (see “To Set Measurement Mode” on page 5-22).
2. Set the output voltage or current (see “To Apply DC Voltage/Current” on page
5-12).
3. Press the On/Off switch for channel 1 or 2 (Ch1 or Ch2).
The channel starts the specified voltage/current output. While the switch is
turned green, the channel continues the output and changes the value
immediately if it is changed.
4. Press the Trigger key.
The spot measurement is performed.
To Next Page
Loading...
Need help?
General
