Keysight Technologies B2961A - To Set Connection Type; To Set Low Terminal State; To Enable or Disable High Capacitance Mode

5-18 Keysight B2961A/B2962A User’s Guide, Edition 3
Front Panel Operations
To Set Source Output
To Set Connection Type
For details on this function, see “2-Wire Connections or 4-Wire Connections” on
page 3-15.
1. Press the Config > Source > Connection function keys.
The Output Connection dialog box opens.
2. In the Ch field, set the channel to which the setting change is applied.
3. Set 2-WIRE or 4-WIRE in the Sensing Type field.
4. To apply the settings, press Apply.
To apply the settings and close the dialog box, press OK.
To cancel the setting change, press the Cancel/Local key.
To Set Low Terminal State
For details on this function, see “Floating” on page 3-16.
1. Press the Config > Source > Connection function keys.
The Output Connection dialog box opens.
2. In the Ch field, set the channel to which the setting change is applied.
3. Set GROUNDED or FLOATING in the Low Terminal State field.
4. To apply the settings, press Apply.
To apply the settings and close the dialog box, press OK.
To cancel the setting change, press the Cancel/Local key.
To Enable or Disable High Capacitance Mode
For details on this function, see “High Capacitance Mode” on page 6-17.
1. Press the Config > Source > Connection function keys.
The Output Connection dialog box opens.
2. In the Ch field, set the channel to which the setting change is applied.
3. Set ON (enable) or OFF (disable) in the High Capacitance Mode field.
4. To apply the settings, press Apply.
To apply the settings and close the dialog box, press OK.