101
Keysight InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
6 Digital Channels
To connect the digital probes to the device under test / 101
Acquiring waveforms using the digital channels / 105
To display digital channels using AutoScale / 105
Interpreting the digital waveform display / 106
To switch all digital channels on or off / 108
To switch groups of channels on or off / 108
To switch a single channel on or off / 108
To change the displayed size of the digital channels / 107
To reposition a digital channel / 109
To change the logic threshold for digital channels / 108
To display digital channels as a bus / 110
Digital channel signal fidelity: Probe impedance and grounding / 113
This chapter describes how to use the digital channels of a Mixed-Signal
Oscilloscope (MSO).
The digital channels are enabled on MSOX2000 X-Series models and
DSOX2000 X-Series models that have the DSOX2MSO upgrade license installed.
Digital channels and serial decode cannot be on at the same time. The [Serial] key
takes precedence over the [Digital] key. Serial triggers can be used when digital
channels are on.
To connect the digital probes to the device under test
1 If necessary, turn off the power supply to the device under test.
To Next Page
Loading...
