Reference 22
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide 311
Environmental Conditions
Probes and Accessories
For a list of the probes and accessories that are compatible with the 2000 X-Series
oscilloscopes, see the data sheet at: www.keysight.com/find/2000X-Series
Maximum input voltage at digital channels
±40 V peak
Environment Indoor use only.
Ambient
temperature
5 to 50 °C
Humidity Maximum Relative Humidity (non-condensing): 95% RH up to 40 °C
From 40 °C to 50 °C, the maximum % Relative Humidity follows the line of
constant dew point
Altitude 4,000 m max
Overvoltage
Category
This product is intended to be powered by MAINS that comply to Overvoltage
Category II, which is typical of cord-and-plug connected equipment.
Pollution Degree The InfiniiVision 2000/3000 X-Series oscilloscopes may be operated in
environments of Pollution Degree 2 (or Pollution Degree 1).
Pollution Degree
Definitions
Pollution Degree 1: No pollution or only dry, non-conductive pollution occurs.
The pollution has no influence. Example: A clean room or climate controlled
office environment.
Pollution Degree 2. Normally only dry non-conductive pollution occurs.
Occasionally a temporary conductivity caused by condensation may occur.
Example: General indoor environment.
Pollution Degree 3: Conductive pollution occurs, or dry, non-conductive
pollution occurs which becomes conductive due to condensation which is
expected. Example: Sheltered outdoor environment.
To Next Page
Loading...
