292 Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
20 Utility Settings
To configure the [Quick Action] key:
1 Press [Utility] > Quick Action > Action; then, select the action that should be
performed:
• Off — disables the [Quick Action] key.
• Quick Measure All — displays a popup containing a snapshot of all the single
waveform measurements. The Source softkey lets you select the waveform
source (which also becomes the source selection in the Measurement
Menu). See Chapter 14, “Measurements,” starting on page 203.
• Quick Print — prints the current screen image. Press Settings to set up the
printing options. See Chapter 19, “Print (Screens),” starting on page 269.
• Quick Save — saves the current image, waveform data, or setup. Press Settings
to set up the save options. See Chapter 18, “Save/Recall (Setups, Screens,
Data),” starting on page 257.
• Quick Recall — recalls a setup, mask, or reference waveform. Press Settings to
set up the recall options. See Chapter 18, “Save/Recall (Setups, Screens,
Data),” starting on page 257.
• Quick Freeze Display — freezes the display without stopping running
acquisitions or un-freezes the display if currently frozen. For more
information, see "To freeze the display" on page 129.
• Quick Trigger Mode — toggles the trigger mode between Auto and Normal, see
"To select the Auto or Normal trigger mode" on page 170.
• Quick Clear Display — clears the display, see "To clear the display" on
page 128.
Once the [Quick Action] key is configured, you simply press it to perform the
selected action.
Adding an Annotation
You can add an annotation to the upper left corner of the oscilloscope's display.
The annotation is useful for documentation purposes, to add notes before
capturing screens.
To add an annotation:
1 On the oscilloscope's front panel, press [Utility].
2 In the Utility Menu, press Annotation.
To Next Page
Loading...
Need help?
General
