264 Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
18 Save/Recall (Setups, Screens, Data)
To navigate storage locations
When saving or recalling files, the softkey in the second position of the Save Menu
or Recall Menu, along with the Entry knob, are used to navigate to storage
locations. The storage locations can be internal oscilloscope storage locations (for
setup files or mask files) or they can be external storage locations on a connected
USB storage device.
The softkey in the second position can have these labels:
• Press to go — when you can push the Entry knob to navigate to a new folder or
storage location.
• Location — when you have navigated to the current folder location (and are not
saving files).
• Save to — when you can save to the selected location.
• Load from — when you can recall from the selected file.
When saving files:
• The proposed file name is shown in the Save to file = line above the softkeys.
• To overwrite an existing file, browse to that file and select it. To create a new file
name, see "To enter file names" on page 264.
To enter file names
To create new file names when saving files to a USB storage device:
1 In the Save Menu, press the File Name softkey.
You must have a USB storage device connected to the oscilloscope for this
softkey to be active.
2 In the File Name Menu, use the Spell, Enter, and Delete Character softkeys to
enter the file name:
• Spell — press this softkey and turn the Entry knob to select the character at
the current position.
• Enter — press this softkey to enter characters and move the cursor to the next
character position. Pushing the Entry knob is the same as pressing the Enter
softkey.
• Delete Character — press this softkey to delete the character at the current
position.
To Next Page
Loading...
Need help?
General
