Keysight Technologies InfiniiVision 2000 X Series User Manual

206 Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
14 Measurements
Measurements Summary
The automatic measurements provided by the oscilloscope are listed in the
following table. All measurements are available for analog channel waveforms. All
measurements except Counter are available for math waveforms other than FFT. A
limited set of measurements is available for math FFT waveforms and for digital
channel waveforms (as described in the following table).
Measurement Valid
for
Math
FFT
*
Valid for
Digital
Channels
Notes
"Snapshot All" on page 207
"Amplitude" on page 209
"Average" on page 212 Yes, Full
Screen
"Base" on page 210
"Bit Rate" on page 217 Yes
"Delay" on page 218 Measures between two sources.
Press Settings to specify the second
source.
"Duty Cycle" on page 218 Yes
"Fall Time" on page 218
"Frequency" on page 216 Yes
"Maximum" on page 209 Yes
"Minimum" on page 209 Yes
"Rising Edge Count" on
page 223
"Falling Edges Count" on
page 223
"Positive Pulse Count" on
page 222

Keysight Technologies InfiniiVision 2000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 2000 X Series
Category	Test Equipment
Language	English