125
Keysight InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
8 Display Settings
To adjust waveform intensity / 125
To set or clear persistence / 127
To clear the display / 128
To select the grid type / 128
To adjust the grid intensity / 129
To freeze the display / 129
To adjust waveform intensity
You can adjust the intensity of displayed waveforms to account for various signal
characteristics, such as fast time/div settings and low trigger rates.
Increasing the intensity lets you see the maximum amount of noise and
infrequently occurring events.
Reducing the intensity can expose more detail in complex signals as shown in the
following figures.
1 Press the [Intensity] key to illuminate it.
This key is located just below the Entry knob.
2 Turn the Entry knob to adjust the waveform instensity.
Waveform intensity adjustment affects analog channel waveforms only (not math
waveforms, referencewaveforms, digital waveforms, etc.).
To Next Page
Loading...
Need help?
General
