Waveform Generator 17
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide 251
• Press the Type softkey and turn the Entry knob to select the modulation type:
• Amplitude Modulation (AM) — the amplitude of the original carrier signal is
modified according to the amplitude of the modulating signal. See "To
set up Amplitude Modulation (AM)" on page 251.
• Frequency Modulation (FM) — the frequency of the original carrier signal is
modified according to the amplitude of the modulating signal. See "To
set up Frequency Modulation (FM)" on page 252.
• Frequency-Shift Keying Modulation (FSK) — the output frequency "shifts"
between the original carrier frequency and a "hop frequency" at the
specified FSK rate. The FSK rate specifies a digital square wave
modulating signal. See "To set up Frequency-Shift Keying Modulation
(FSK)" on page 254.
To set up Amplitude Modulation (AM)
In the Waveform Generator Modulation Menu (under [Wave Gen] > Settings >
Modulation):
1 Press the Type softkey and turn the Entry knob to select Amplitude Modulation
(AM).
2 Press the Waveform softkey and turn the Entry knob to select the shape of the
modulating signal:
• Sine
• Square
• Ramp
• Sine Cardinal
• Exponential Rise
• Exponential Fall
When the Ramp shape is selected, a Symmetry softkey appears so that you can
specify the amount of time per cycle that the ramp waveform is rising.
3 Press the AM Freq softkey and turn the Entry knob to specify the frequency of
the modulating signal.
4 Press the AM Depth softkey and turn the Entry knob to specify the amount of
amplitude modulation.
To Next Page
Loading...
