300 Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
21 Web Interface
Remote Programming with Keysight IO Libraries
While the SCPI Commands applet window lets you enter and remote
programming commands, remote programming for automated test and data
acquisition is typically done using the Keysight IO Libraries, which are separate
from the instrument's web interface.
The Keysight IO Libraries let a controller PC communicate with Keysight
InfiniiVision oscilloscopes via their USB, LAN (when the LAN/VGA option module is
installed), or GPIB (when the GPIB option module is installed) interfaces.
The Keysight IO Libraries Suite connectivity software to enables communication
over these interfaces. You can download the Keysight IO Libraries Suite from
www.keysight.com/find/iolib.
Information about controlling the oscilloscope through remote commands is
contained in the Programmer's Guide.
For more information about connecting to the oscilloscope, refer to the Keysight
Technologies USB/LAN/GPIB Interfaces Connectivity Guide. For a printable
electronic copy of the Connectivity Guide, direct your Web browser to
www.keysight.com and search for "Connectivity Guide".
Save/Recall
You can save setup files, screen images, waveform data files, or mask files to your
PC via the oscilloscope's web interface (see "Saving Files via the Web
Interface" on page 300).
You can recall setup files, reference waveform data files, or mask files from your PC
via the oscilloscope's web interface (see "Recalling Files via the Web
Interface" on page 301).
Saving Files via the Web Interface
To save setup files, screen images, waveform data, Lister data, or mask files to
your PC via the oscilloscope's web interface:
1 Access the oscilloscope's web interface (see "Accessing the Web Interface" on
page 296).
2 When the oscilloscope's web interface is displayed, select the Save/Recall tab
from the left side of the Welcome screen.
To Next Page
Loading...
Need help?
General
