Keysight Technologies InfiniiVision 2000 X Series

275
Keysight InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
20 Utility Settings
I/O Interface Settings / 275
Setting up the Oscilloscope's LAN Connection / 276
File Explorer / 279
Setting Oscilloscope Preferences / 281
Setting the Oscilloscope's Clock / 284
Setting the Rear Panel TRIG OUT Source / 284
Enabling Remote Command Logging / 285
Performing Service Tasks / 286
Configuring the [Quick Action] Key / 291
Adding an Annotation / 292
This chapter explains oscilloscope utility functions.
I/O Interface Settings
The oscilloscope can be accessed and/or controlled remotely via these I/O
interfaces:
• USB device port on the rear panel (square shaped USB port).
• LAN interface when a LAN/VGA module is installed in the rear panel module
slot.
• GPIB interface when a GPIB module is installed in the rear panel module slot.
To configure the I/O interfaces:
1 On the oscilloscope's front panel, press [Utility].
2 In the Utility Menu, press I/O.