286 Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
20 Utility Settings
Your selection takes effect when remote command logging is enabled.
This option applies to both screen and file logging.
5 Press File Name to open the Log Filename menu where you can specify the name
of the file (on the USB storage device) to which remote commands are logged.
6 Press Display On to enable or disable the screen display of logged remote
commands and their return values (if applicable).
7 Press Transparent to disable or enable a transparent background for the remote
command logging screen display.
Enable to make the background transparent. This lets you view underlying
waveforms.
Disable for a solid background which makes the logged remote commands
easier to read.
Performing Service Tasks
The Service Menu (under [Utility] > Service) lets you perform service-related tasks:
• "To perform user calibration" on page 287
• "To perform hardware self test" on page 289
• "To perform front panel self test" on page 290
• "To display oscilloscope information" on page 290
• "To display the user calibration status" on page 290
For other information related to oscilloscope maintenance and service, see:
• "To clean the oscilloscope" on page 290
• "To check warranty and extended services status" on page 290
• "To contact Keysight" on page 291
• "To return the instrument" on page 291
To Next Page
Loading...
