Keysight Technologies InfiniiVision 2000 X Series User Manual

Acquisition Control 12
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide 187
The higher the number of averages, the slower the displayed waveform responds
to waveform changes. You must compromise between how quickly the waveform
responds to changes and how much you want to reduce the displayed noise on
the signal.
To use the Averaging mode:
1 Press the [Acquire] key, then press the Acq Mode softkey until the Averaging
mode is selected.
2 Press the #Avgs softkey and turn the Entry knob to set the number of averages
that best eliminates the noise from the displayed waveform. The number of
acquisitions being averaged is displayed in the # Avgs softkey.
Figure 38 Random noise on the displayed waveform

Keysight Technologies InfiniiVision 2000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 2000 X Series
Category	Test Equipment
Language	English