To Next Page

To Previous Page

258 Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide

18 Save/Recall (Setups, Screens, Data)

• Setup (*.scp) — The oscilloscope's horizontal timebase, vertical sensitivity,

trigger mode, trigger level, measurements, cursors, and math function

settings that tell the oscilloscope how to make a particular measurement.

See "To save setup files" on page 259.

• 8-bit Bitmap image (*.bmp) — The complete screen image in a reduced color

(8-bit) bitmap format. See "To save BMP or PNG image files" on page 259.

• 24-bit Bitmap image (*.bmp) — The complete screen image in a 24-bit color

bitmap format. See "To save BMP or PNG image files" on page 259.

• 24-bit image (*.png) — The complete screen image in a 24-bit color PNG

format that uses lossless compression. Files are much smaller than the BMP

format. See "To save BMP or PNG image files" on page 259.

• CSV data (*.csv) — This creates a file of comma-separated values of all

displayed channels and math waveforms. This format is suitable for

spreadsheet analysis. See "To save CSV, ASCII XY, or BIN data files" on

page 260.

• ASCII XY data (*.csv) — This creates separate files of comma-separated values

for each displayed channel. This format is also suitable for spreadsheets. See

"To save CSV, ASCII XY, or BIN data files" on page 260.

• Reference Waveform data (*.h5) — Saves waveform data in a format that can be

recalled to one of the oscilloscope's reference waveform locations. See "To

save reference waveform files to a USB storage device" on page 263.

• Multi Channel Waveform data (*.h5) — Saves multiple channels of waveform

data in a format that can be opened by the N8900A InfiniiView oscilloscope

analysis software. You can recall the first Analog or Math channel from a

multi channel waveform data file.

• Binary data (*.bin) — This creates a binary file, with a header, and data in the

form of time and voltage pairs. This file is much smaller than the ASCII XY

data file. See "To save CSV, ASCII XY, or BIN data files" on page 260.

• Lister data (*.csv) — This is a CSV format file containing serial decode row

information with commas separating the columns. See "To save Lister data

files" on page 262.

• Mask (*.msk) — This creates a mask file in a Keysight proprietary format that

can be read by Keysight InfiniiVision oscilloscopes. A mask data file includes

some oscilloscope setup information, but not all setup information. To save

all setup information including the mask data file, choose "Setup (*.scp)"

format instead. See "To save masks" on page 263.

Keysight Technologies InfiniiVision 2000 X Series User Manual

Questions and Answers: