Cursors 14
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide 149
In the Cursor Units menu:
You can press the XUnits softkey to select:
• Seconds (s).
• Hz (1/s).
• Phase (°) — when selected, use the Use X Cursors softkey to
set the current X1 location as 0 degrees and the current
X2 location as 360 degrees.
• Ratio (%) — when selected, use the Use X Cursors softkey to
set the current X1 location as 0% and the current X2
location as 100%.
You can press the YUnits softkey to select:
• Base — the same units used for the source waveform.
• Ratio (%) — when selected, use the Use YCursors softkey to
set the current Y1 location as 0% and the current Y2
location as 100%.
For phase or ratio units, once the 0 and 360 degree or 0 and 100% locations are
set, adjusting cursors will display measurements relative to the set locations.
7 Adjust the selected cursor(s) by turning the Cursors knob.
To Next Page
Loading...
