Keysight M8195A - Page 104

2 M8195A User Interface
104 Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide
 Marker
This option allows to enable or disable the marker.
 New Seq. (New Sequence)
Select the check box to start a new sequence.
 Scen. End
Select the check box to mark end of the scenario.
 Seq. Loop (Sequence Loop)
Specifies the sequence loop count (number of times the selected sequence is
to be repeated).
 Seq.Adv. (Sequence Advance)
Allows the user to set the sequence advancement mode.
Any of the following sequence advancement modes can be selected:
 Auto (Automatic): After having executed all loops, the sequencer
advances to the next sequence automatically. No external interaction is
required for advancement.
 Cond (Conditional): The sequencer repeats the current sequence until it
receives the correct advancement event. After having received the
advancement event, the current sequence is played to the end before
switching to the next one.
 Repeat: After having executed all loops the sequencer stops and plays the
last value of the current sequence. After having received the
advancement event, the sequencer starts playing the next sequence.
When receiving the advancement event before having played all
repetitions, all repetitions will be played before moving to the next
sequence.
 Single: Once a sequence is executed, the sequencer stops and plays the
last value of the sequence. After having received the next advancement
event, the process is repeated until having executed all loops of the
current sequence. Then the execution advances to the next sequence.
 Idle Delay
The field is enabled only when the Entry Type is chosen as “Idle”. It is used to
insert a numeric idle delay value into the sequence.
 Idle Sample
Idle Sample is the sample played during the pause time. The field is enabled
only when the Entry Type is chosen as “Idle”. It is used to insert a numeric idle
sample value into the sequence. In case of interpolated mode, there are two
idle sample values corresponding to I and Q data, respectively. So, for
interpolated mode there will be two columns for idle samples i.e. Idle Samp. I
and Idle Samp. Q.
 (Insert Above)
Insert a new sequence entry row above the selected entry.
 (Insert Below)
Insert a new sequence entry row below the selected entry.
 (Delete)
Delete the selected sequence entries.