Keysight M8195A - Trac[1|2|3|4]:Imp:scal:[Stat][?] off; Trac[1|2|3|4]:Del

6 General Programming
254 Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide
6.21.13 :TRAC[1|2|3|4]:IMP:SCAL:[STAT][?] OFF|ON|0|1
Command
:TRAC[1|2|3|4]:IMP:SCAL
Long
:TRACe[1|2|3|4]:IMPort:SCALe
Parameters
OFF|ON|0|1
Parameter Suffix
None
Description
Set or query the scaling state for the file import. If scaling is disabled, an imported
waveform is not scaled. If the waveform contains out-of-range values, the import
command returns an error. If scaling is enabled, an imported waveform is scaled, so
that it uses the whole DAC range. This also allows importing waveforms with out-of-
range values.
The scaling affects all file formats. But for files of type LICensed, if scaling is disabled,
the value set by the CARR:SCAL command is used. If scaling is enabled, CARR:SCAL
is ignored and an optimal scaling factor is calculated, so that the whole DAC range is
used.
Example
Command
:TRAC:IMP:SCAL ON
6.21.14 :TRAC[1|2|3|4]:DEL
Command
:TRAC[1|2|3|4]:DEL
Long
:TRACe[1|2|3|4]:DELete
Parameters
<segment_id>– id of the segment
Parameter Suffix
None
Description
Delete a segment. The command can only be used in program mode.
If the channel is sourced from Extended Memory, the same segment is deleted on all
other channels sourced from Extended Memory.
Example
Command
:TRAC:DEL 1