Keysight M8195A - Output[1|2|3|4]:Filter:qrate:scale[?] <Scale>|Minimum|Maximum; Output[1|2|3|4]:Filter:qrate:delay[?] <Delay>|Minimum|Maximum

General Programming 6
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide 215
6.13.17 :OUTPut[1|2|3|4]:FILTer:QRATe:SCALe[?] <scale>|MINimum|MAXimum
Command
:OUTP:FILT:QRAT:SCAL[?]
Long
:OUTPut:FILTer:QRATe:SCALe[?]
Parameters
<scale>|MINimum|MAXimum
Parameter Suffix
None
Description
Set or get the FIR filter scaling factor for a channel to be used when the Sample Rate
Divider for the Extended Memory is 4. The range is between 0 and 1.
Example
Command:
OUTP:FILT:QRAT:SCAL 0.9
6.13.18 :OUTPut[1|2|3|4]:FILTer:QRATe:DELay[?] <delay>|MINimum|MAXimum
Command
:OUTP:FILT:QRAT:DEL[?]
Long
:OUTPut:FILTer:QRATe:DELay[?]
Parameters
<delay>|MINimum|MAXimum
Parameter Suffix
[s|ms|us|ns|ps]
Description
Set or get the FIR filter delay for a channel to be used when the Sample Rate Divider
for the Extended Memory is 4. The range is -200ps..+200ps. The delay value has only
effect for filter types NYQuist and LINear.
The command form modifies the FIR filter coefficients according to the set delay
value.
Example
Command:
OUTP:FILT:QRAT:DEL 10ps