Keysight M8195A - Initiate:gate[:State][?] off

General Programming 6
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide 183
6.8.6 :INITiate:GATE[:STATe][?] OFF|ON|0|1
Command
:INIT:GATE:STAT[?]
Long
:INITiate:GATE:STATe[?]
Parameters
OFF | ON | 0 | 1
Parameter Suffix
None
Description
Set or query the gate mode. This command must be used together with INIT:CONT
to set the trigger mode.
 0/OFF – Gate mode is off.
 1/ON – Gate mode is on. If continuous mode is off, the trigger mode is
“gated”.
Example
Command
:INIT:GATE:STAT ON
Query
:INIT:GATE:STAT?
Table 31: Trigger mode settings
INIT:CONT
INIT:GATE
Trigger Mode
0
0
Triggered
0
1
Gated
1
0
Continuous
1
1
Continuous