Use this tab to create a sequence with one or more (upto 16M) sequence entries. The
characteristics of a sequence depend on the parameters’ values of the constituent
entries. This tab allows to create, configure, and send new sequence configuration to
the instrument, and also to extract the existing one. The sequencing functionality is only
available for channels with ‘extended’ memory, and all the channels share the same
sequence information (i.e. the sequence created using this tab will be same for all the
channels sourced from ‘extended’ memory). The option ‘SEQ’ must be installed for
sequencing to work.
You can also configure various sequence/control parameters using this tab.
The following figure shows Sequence/Control tab (STScenario mode):
To Next Page
Loading...
