Keysight M8195A - Arm[:Sequence][:Start][:Layer]:Event:slope[?] Positive|Negative|Either; Trigger[:Sequence][:Start]:Source:enable[?] Trigger|Event

6 General Programming
188 Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide
6.8.14 :ARM[:SEQuence][:STARt][:LAYer]:EVENt:SLOPe[?] POSitive|NEGative|EITHer
Command
:ARM:EVEN:SLOP[?]
Long
:ARM:EVENt:SLOPe[?]
Parameters
POSitive|NEGative|EITHer
Parameter Suffix
None
Description
Set or query the event input slope.
 POSitive – rising edge
 NEGative – falling edge
 EITHer – both
Example
Command
:ARM:EVEN:SLOP POS
Query
:ARM:EVEN:SLOP?
6.8.15 :TRIGger[:SEQuence][:STARt]:SOURce:ENABle[?] TRIGger|EVENt
Command
:TRIG:SOUR:ENAB[?]
Long
:TRIGger:SOURce:ENABle[?]
Parameters
TRIGger|EVENt
Parameter Suffix
None
Description
Set or query the source for the enable event.
 TRIGger - trigger input
 EVENt - event input
Example
Command
:TRIG:SOUR:ENAB TRIG
Query
:TRIG:SOUR:ENAB?