Keysight M8195A - Output[1|2|3|4]:Filter:frate:scale[?] <Scale>|Minimum|Maximum; Output[1|2|3|4]:Filter:frate:delay[?] <Delay>|Minimum|Maximum

General Programming 6
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide 211
Description
Set or get the predefined FIR filter type for a channel to be used when the Sample
Rate Divider for the Extended Memory is 1.
 LOWPass – equiripple lowpass filter with a passband edge at 75% of
Nyquist
 ZOH – Zero-order hold filter
 USER – User-defined filter
The command form modifies the FIR filter coefficients according to the set filter type,
except for type USER.
Example
Command:
OUTP:FILT:FRAT:TYPE LOWP
6.13.9 :OUTPut[1|2|3|4]:FILTer:FRATe:SCALe[?] <scale>|MINimum|MAXimum
Command
:OUTP:FILT:FRAT:SCAL[?]
Long
:OUTPut:FILTer:FRATe:SCALe[?]
Parameters
<scale>|MINimum|MAXimum
Parameter Suffix
None
Description
Set or get the FIR filter scaling factor for a channel to be used when the Sample Rate
Divider for the Extended Memory is 1. The range is between 0 and 1.
Example
Command:
OUTP:FILT:FRAT:SCAL 0.9
6.13.10 :OUTPut[1|2|3|4]:FILTer:FRATe:DELay[?] <delay>|MINimum|MAXimum
Command
:OUTP:FILT:FRAT:DEL[?]
Long
:OUTPut:FILTer:FRATe:DELay[?]
Parameters
<delay>|MINimum|MAXimum
Parameter Suffix
[s|ms|us|ns|ps]
Description
Set or get the FIR filter delay for a channel to be used when the Sample Rate Divider
for the Extended Memory is 1. The range is -50ps..+50ps. The delay value has only
effect for filter type LOWPass.
The command form modifies the FIR filter coefficients according to the set delay
value.