Keysight M8195A - Frequency Status Subsystem; Sequence Status Subsystem

General Programming 6
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide 177
6.7.6 Frequency Status Subsystem
The Frequency Status register contains the frequency conditions of the module.
The following SCPI commands and queries are supported:
:STATus:QUEStionable:FREQuency[:EVENt]?
:STATus:QUEStionable:FREQuency:CONDition?
:STATus:QUEStionable:FREQuency:ENABle[?]
:STATus:QUEStionable:FREQuency:NTRansition[?]
:STATus:QUEStionable:FREQuency:PTRansition[?]
Table 26: Frequency status register
Bit Number
Decimal Value
Definition
0 Frequency warning
1
Output signal is invalid, because of an
instable or missing external reference clock.
6.7.7 Sequence Status Subsystem
The Sequence Status register is used to indicate errors in the sequence table data
provided by the user.
The following SCPI commands and queries are supported:
:STATus:QUEStionable:SEQuence[:EVENt]?
:STATus:QUEStionable:SEQuence:CONDition?
:STATus:QUEStionable:SEQuence:ENABle[?]
:STATus:QUEStionable:SEQuence:NTRansition[?]
:STATus:QUEStionable:SEQuence:PTRansition[?]
Table 27: Sequence status register
Bit Number
Decimal Value
Definition
0 Sequence data error
1
Sequence has errors
1 Sequence linear-playtime error
2
Sequence has a linear-playtime error