Keysight M8195A - DUC Status Subsystem; Connection Status Subsystem

6 General Programming
178 Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide
6.7.8 DUC Status Subsystem
The DUC Status register contains the conditions after up-conversion of an imported
file for the individual channels.
The following SCPI commands and queries are supported:
:STATus:QUEStionable:DUC[:EVENt]?
:STATus:QUEStionable:DUC:CONDition?
:STATus:QUEStionable:DUC:ENABle[?]
:STATus:QUEStionable:DUC:NTRansition[?]
:STATus:QUEStionable:DUC:PTRansition[?]
Table 28: DUC status register
Bit Number
Decimal Value
Definition
0 DUC Amplitude clipped
1
The DUC amplitude for output 1 has been clipped to the highest/lowest
possible DAC value.
1 DUC Amplitude clipped
2
The DUC amplitude for output 2 has been clipped to the highest/lowest
possible DAC value.
2 DUC Amplitude clipped
4
The DUC amplitude for output 3 has been clipped to the highest/lowest
possible DAC value.
3 DUC Amplitude clipped
8
The DUC amplitude for output 4 has been clipped to the highest/lowest
possible DAC value.
6.7.9 Connection Status Subsystem
The Connection Status register contains the state of the USB connection to the
M8195A module.
The following SCPI commands and queries are supported:
:STATus:QUEStionable:CONNection[:EVENt]?
:STATus:QUEStionable:CONNection:CONDition?
:STATus:QUEStionable:CONNection:ENABle[?]
:STATus:QUEStionable:CONNection:NTRansition[?]
:STATus:QUEStionable:CONNection:PTRansition[?]
Table 29: Connection status register
Bit Number
Decimal Value
Definition
0 USB disconnected
1
USB module connection state