Keysight M8195A - Stable Subsystem; Source]:Stable:reset; Source]:Stable:data[?] <Sequence_Table_Index>,(<Length>|<Block>|<Value>,<Value

General Programming 6
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide 225
6.18 :STABle Subsystem
Use the Sequence Table subsystem to prepare the instrument for sequence and
scenario generation. The Sequencing capabilities can only be used by the channels
sourced from Extended Memory. These channels share a common Sequence Table
and execute the same sequence or scenario. The channels sourced from Internal
Memory play only one waveform.
Follow these steps for all function modes:
 First create waveform data segments in the module memory like described
in the “Arbitrary Waveform Generation” paragraph of the “TRACe
subsystem”.
 Create sequence table entries that refer to the waveform segments using
the STAB:DATA command.
6.18.1 [:SOURce]:STABle:RESet
Command
:STAB:RES
Long
:STABle:RESet
Parameters
None
Parameter Suffix
None
Description
Reset all sequence table entries to default values.
Example
Command
:STAB:RES
6.18.2 [:SOURce]:STABle:DATA[?]
<sequence_table_index>,(<length>|<block>|<value>,<value>…)
Command
:STAB:DATA[?]
Long
:STABle:DATA[?]
Parameters
<sequence_table_index>,(<length>|<block>|<value>,<value>…)
Parameter Suffix
None