Keysight M8195A - Arm[:Sequence][:Start][:Layer]:Trigger:slope[?] Positive|Negative|Either

General Programming 6
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide 185
6.8.9 :ARM[:SEQuence][:STARt][:LAYer]:TRIGger:SLOPe[?] POSitive|NEGative|EITHer
Command
:ARM:TRIG:SLOP[?]
Long
:ARM:TRIGger:SLOPe[?]
Parameters
POSitive|NEGative|EITHer
Parameter Suffix
None
Description
Set or query the trigger input slope.
 POSitive – rising edge
 NEGative – falling edge
 EITHer – both
Example
Command
:ARM:TRIG:SLOP POS
Query
:ARM:TRIG:SLOP?