General Programming 6
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide 159
6.5 System Related Commands (SYSTem Subsystem)
6.5.1 :SYSTem:EIN:MODE[?] EIN|TOUT
The Event In and Trigger Out functionality use a shared connector on the front panel.
This command switches between trigger output and event input functionality. When
Trigger Out functionality is active, Event In functionality is disabled and vice versa.
Note: Trigger Out is for future use. There are no plans to support Trigger Out
functionality directly from M8195A firmware. Trigger Out is tentatively supported by
81195A optical modulation generator software (V2.1 or later).
To Next Page
Loading...
