will be automatically set to the same level. Acceptable range for this
parameter is -1/+1, being the full dynamic range of the instrument’s DAC.
DAC Min
DAC Max: Imported waveforms may occupy a limited range of the DAC’s full
scale. This parameter sets the minimum level. If set to a higher level than DAC
Max, this will be automatically set to the same level. Acceptable range for this
parameter is -1/+1, being the full dynamic range of the instrument’s DAC.
Preview Section
Waveform Preview Toolbar
The waveform preview toolbar includes the icons which provide different
functionality to preview the waveform. For details, see Waveform Preview
Toolbar.
Show Next Waveform Preview
This checkbox affects the behavior of the preview for the next waveform.
If selected, a preview of the imported waveform is displayed. Leave this
checkbox unselected to speed up the import of large waveforms.
Save To File…
Signals can be stored in files in whether BIN (for non IQ modes) or IQBIN (for
IQ modes) formats. These files may be reused within the Import Waveform tab.
Send To Instrument
Signal will be transferred to the selected segments of the selected channels.
The previous running status for the target instrument will be preserved but
sampling rate may be modified depending on the waveform requirements.
Set Defaults
All the imported waveform parameters are set automatically to their
corresponding default values.
To Next Page
Loading...
