Keysight M8195A - Page 128

3 Sequencing
128 Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide
b
b
b
Offset
RUN
Adv Event
Adv Event
Adv Event
Adv Event
Stop
(Abort)
Offset
a
1
a
2
Auto Conditional Repeated
Single
Last
Value
a1 bba2 b
c2c1b
a2a1
d2d1
Figure 42: Trigger mode continuous
Trigger Mode Triggered
An Offset value is provided after programming. A trigger starts the sequence.
The following sequence advancement modes are available:
Auto: The sequence is executed the number of times specified by its loop count. Then
the last sample is played at the end.
Repeat: This advancement mode is quite the same like “Auto” with the difference that
an advancement event is required at the end.
Single: An advancement event is required for each sequence repetition.
Conditional: The sequence is played infinitely after receiving a trigger. After being
stopped (See SCPI command :ABORt[1|2|3|4]) the offset value is played.
The following segment advancement modes are available:
 Auto
 Conditional (Advancement Event)
 Repeat (Advancement Event)
 Single (Advancement Event)