Keysight M8195A - Page 135

Sequencing 3
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide 135
b
Offset
RUN
a
1
a
2
Auto
Conditional
Single
a1
b2b1a2
Adv Event
Last
Value
b
a
1
a
2
a1 b2b1a2
Adv Event
Value
b
a
2
ccc
Adv Event
Value
Last
Last
bd1c
Adv Event
d2
Last
Value
Adv Event
b
a
2
ccc
Adv Event
Value
Last
b
d1
c
Adv Event
d2
Last
Value
Value
Last
b
a
1
a
2
a1 b2b1a2
Last
Value
Adv Event
Offset
Stop
(Abort)
Repeated
Figure 52: Trigger mode continuous
Trigger Mode Triggered
An Offset value is provided after programming. A trigger starts the scenario.
The following scenario advancement modes are available:
Auto: The scenario is executed the number of times specified by its loop count. Then the
last sample is played at the end.
Repeat: This advancement mode is quite the same like “Auto” with the difference that
an advancement event is required at the end.
Single: An advancement event is required for each scenario repetition.
Conditional: The scenario is played infinitely after receiving a trigger. After being
stopped (See SCPI command :ABORt[1|2|3|4]) the offset value is played.
The following segment/sequence advancement modes are available:
 Auto
 Conditional (Advancement Event)
 Repeat (Advancement Event)
 Single (Advancement Event)