Truncate (TRUNcate, Truncate)
The first two steps are identical to the “Timing” mode. Then the input waveform is
resampled. Decrease the output record length to the next integer fulfilling the
granularity and remove the corresponding number of samples from the end of the
waveform.
Adjust the resampling factor.
Adjust the output sample rate.
Zero-Padding (PADDing, Zero_Padding)
The first two steps are identical to the “Timing” mode. Then the input waveform is
resampled. Increase the output record length to the next integer fulfilling the
granularity and add the corresponding number of zero-samples at the end of the
waveform.
Adjust the resampling factor.
Adjust the output sample rate.
Repeat (REPeat, Repeat)
The first two steps are identical to the “Timing” mode. Then adjust the output record
length by the minimum number of repetitions to fulfill the granularity.
Adjust the resampling factor.
Adjust the output sample rate.
To Next Page
Loading...
