Keysight M8195A - Page 53

M8195A User Interface 2
Keysight M8195A Revision 2 – Arbitrary Waveform Generator User’s Guide 53
This tab has the following configurable fields:
 Arm mode
 Armed – Signal generation starts when an “enable” event is received as
defined by the trigger mode.
 Self – Signal generation starts as defined by the trigger mode.
 Trigger mode
 Continuous – Signal generation starts immediately after pressing the Run
button. No trigger needed.
 Triggered – Signal generation starts after a trigger is received.
 Gated – Signal generation starts when a rising edge is received on the trigger
input and pauses when a falling edge is received. Signal generation restarts
after the next rising edge.
 Threshold
Specifies the threshold voltage for a software trigger or event.
 Polarity
Specifies the polarity for a software trigger or event viz. Negative, Positive, or
Either.
 Operation
Specifies whether the trigger or event operation is Synchronous or
Asynchronous. Operation mode is same for both trigger and event input.
 Frequency
Specifies the frequency for internal trigger.
 Force Trigger
Use this button to send a software trigger to a channel.
 Force Event
Use this button to send a software event to a channel.
 Force Enable
Use this button to send a software “enable” to a channel.