Constellation Diagram Section
The constellation diagram section shows a graphic representation of the ideal
constellation corresponding to the selected modulation scheme and modulation
parameters. It also shows the location of symbols from valid modulation definition files
for validation. The line above the constellation diagram shows the following modulation
parameters:
BPS (Bits Per Symbol)
Per symbol rotation angle (in degrees)
I/Q delay (in symbol times)
Compilation and Panel Control Section
Save To File…
Signals can be stored in files in whether BIN (for non IQ modes) or IQBIN (for
IQ modes) formats. These files may be reused within the Import Waveform tab.
Send To Instrument
Signal will be transferred to the selected segments of the selected channels.
The previous running status for the target instrument will be preserved but
sampling rate may be modified depending on the waveform requirements.
Set Defaults
All the waveform parameters are set automatically to their corresponding
default values.
Abort
This button allows canceling signal calculation at any moment. It only shows
up during signal compilation.
To Next Page
Loading...
