Precision Seed Drills
102
MAXIMA 2
Instructions for work
Stationary checking:
- Lift the seed drill.
- Engage the tractor pto and increase speed gradually
until reaching the recommended blower speed.
- Fill hoppers with seeds.
- Disengage the other seeding units by hand (Refer to
"Manual seeding unit disengagement" chapter).
- Lift the observation flap (1).
- Turn the seed drill wheel through several revolutions
by hand to monitor seed take-up by the disk. If
doubles or misses are noticed during the seed take-up
control, modify the selector position.
- Repeat procedure until obtaining the right setting.
After checking:
- Lower control hatch and engage all other seeding
units.
- Carry out same setting for each seeding unit.
If you notice seed doubles on the disk, move
selector (1) of one or several graduations in
direction 0.
If you notice seed misses on the disk, move
selector (1) of one or several graduations in
direction 30.
The marking enables identical setting of each
seeding unit.
To Next Page
Loading...
