KUHN MAXIMA 2 - Adjusting the Intermediate Axial Wheel Scrapers; Adjusting the Scrapers Position

Optional equipment
Precision Seed Drills
MAXIMA 2
129
Adjusting the scraper's position
The scraper's position must be adjusted according to the
sowing conditions:
- Position (a): Slightly wet conditions.
Loosen nut (1) to reduce distance between scraper (2)
and the wheel.
- Position (b): Dry conditions.
Tighten nut (1) to increase distance between scraper (2)
and the wheel.
Repeat procedure on each seeding unit.
Adjusting the intermediate axial wheel
scrapers
The scraper removes soil build-up around the wheel.
Adjusting the plates:
- Loosen nut (1).
- Position plate (2) closest to the wheel, but without
touching it. Rotate wheel once to check that it is not in
contact.
- Tighten screws (1).
Repeat procedure on each seeding unit.

Machine use
In very wet, sticky or stony conditions, the wheel can be
folded upwards to prevent damage on the wheel and
ensure seeding precision.
- Remove R-clips (1).
- Mover levers (2) rearwards ro raise the wheel.
- Insert split pins (1).
Repeat procedure on each seeding unit.
In slightly wet conditions, reduce spacing
between plate and wheel as much as possible to
reduce wear.