Precision Seed Drills
134
MAXIMA 2
Optional equipment
Adjustment of the tamping wheel cleaners
The cleaners remove soil build up around the tamping
wheels.
Lateral adjustment
- Loosen nut (1).
- Center cleaner (2) with regards to wheel (3).
- Tighten nut (1).
- Repeat procedure on the other cleaner.
Adjusting the scraper's position
The scraper's position must be adjusted according to the
sowing conditions:
• Position (a): Slightly wet conditions.
Loosen nut (1) to reduce distance between scraper (2)
and the wheel.
• Position (b): Dry conditions.
Tighten nut (1) to increase distance between scraper (2)
and the wheel.
Repeat procedure on each seeding unit.
Adjusting the plates
- Loosen nut (1).
- Adjust plate (2) to bring it closer to the tamping wheel
but without touching it. Rotate wheel once to check
that it is not in contact.
- Tighten screws (1).
- Repeat procedure on each seeding unit.
In slightly wet conditions, reduce spacing
between plate and wheel as much as possible to
reduce wear.
To Next Page
Loading...
