KUHN MAXIMA 2 - Adjusting the Length (M)

Precision Seed Drills
80
MAXIMA 2
Instructions for work
Adjusting the length (M)
- Unscrew the 2 bolts (1).
- Move side marker extension (2) to obtain required
length M.
- Check that spacer (3) located between the rigid arm
and the pivoting arm is fully inside the rigid arm.
- Tighten bolts (1).
Repeat procedure on the second side marker.
For models 9 m (29’6’’):
- Unscrew the 2 bolts (1).
- Move side marker extension (2) to obtain required
length M.
- Tighten bolts (1).
Repeat procedure on the second side marker.
The spacer prevents deterioration of the
moving arm when tightening the screws.
You are recommended to check this setting in
the field, by inspecting several runs.
You are recommended to check this setting in
the field, by inspecting several runs.