Precision Seed Drills
160
MAXIMA 2
Optional equipment
Man. calibration
After having preset the microgranulator, it is necessary
to carry out a calibration test to know the real product
volume applied.
Preparing the machine:
- Divert a product transfer tube (1) towards a container.
- Position a container (2) underneath the metering unit.
Checking flow rate:
- Travel a distance of 100 m (328’1’’) for the drive shaft
(1) to rotate 64 times which corresponds to
100 m (328’1’’) linear.
The flow can vary according to the product,
the ambient temperature and the humidity
level.
Proceed with regular calibration tests to check
the fertilizer is properly adjusted.
To Next Page
Loading...
