Instructions for work
Precision Seed Drills
MAXIMA 2
85
Fitting distribution disks
- Open hood (1).
- Install distribution disk (2) on drive shaft (3).
- Close hood (1).
Selecting and fitting seed ejectors
When the machine is used with disks with only one row
of holes, the ejector BNB0083 (1) must be fitted.
When disks are not fitted with agitator blades, install
spacer BNB0048 (1).
When the disks are fitted with agitator blades, spacer
BNB0048 (1) must be removed.
Before changing a disk, empty the seeding
unit hopper.
Mark disks prior to removing them in order to
determine their respective position. A disk
must always be fitted on the same sowing
unit.
When disks are fitted with agitator blades,
position disks with agitator blades pointing
inwards.
Check that the distribution disk is properly
positioned on the drive shaft.
This ejector must always be fitted whatever
the seed variety.
The agitator blades fitted on the disk enable
preventing seed bridging in the casing.
Spacer BNB0048 stops small seeds from
flowing freely through the groove.
To Next Page
Loading...
