2KJ/2KH
1-5-32
16. Remove two scanner wire stoppers and
frame securing tools.
17. Focusing on the locating ball of the wire
drum, move aside the wires to inside.
18. Move the mirror 2 frame from side to side to
correctly locate the wires in position.
19. Put the mirror 1 frame on the scanner rail
and move it toward the left side of the
machine.
20. Insert the frame securing tools into the posi-
tioning holes (leftmost holes) at the front and
rear of the scanner unit and screw the mirror
1 frame while securing both the mirror 1
frame and the mirror 2 frame.
21. Remove two frame securing tools.
22. Refit all the removed parts.
Figure 1-5-55
Frame securing tool
Frame securing tool
Mirror 2 frame
Mirror 1 frame
To Next Page
Loading...
