Kyocera TASKalfa 255 - Gigabit Ethernet Board

11-4
Appendix > Optional Equipment
2
Remove the covers.
3
Install the memory module.
1 Remove the memory module from its package.
2 With the memory connection terminal pointing toward the socket, align the cut-out part with
the socket terminal and insert directly in at an angle.
3 Carefully press the inserted memory down and into the machine.
4 Reinstall the covers.
Removing the Memory Module
To remove a memory module, remove the right cover and the memory slot cover from the machine. Then, carefully push
out the two socket clamps. Ease the memory module out of the socket to remove.
Verifying the Expanded Memory
To verify that the memory module is working properly, test it by printing a status page.
Refer to Report on page 9-5.
Gigabit Ethernet Board
The Gigabit Ethernet Board provides a high-speed connection for the Gigabit-per-second interface. Since the kit was
designed to work with TCP/IP, NetWare, NetBEUI, and AppleTalk protocols, in the same way as the main unit, it fulfills
the network printing demands on Windows, Macintosh, and UNIX environments. This expansion kit is also compatible
with ThinPrint.
IMPORTANT
Before inserting a memory module in the machine, make sure that the machine is
switched off.