Page 186
MegaRAID SAS Software User GuideChapter 5: MegaRAID Command Tool
| Controller Property-Related Options
5.8.10 Display Time and Date on
Controller
Use the command in the following table to display the time and date on the selected
controller(s).
5.8.11 Get Connector Mode Use the command in the following table to display which ports are enabled
(Internal/External, 0/1) on the MegaRAID SAS 8888ELP RAID controller.
NOTE: This command is reserved strictly for the SAS 8888ELP RAID controller at this
time. You must enable specific ports depending on how you intend to use the controller.
5.8.12 Set Connector Mode Use the command in the following table to set (enable) the connectors for the
MegaRAID SAS 8888ELP RAID connectors that are listed in Section 5.8.11, Get
Connector Mode.
NOTE: This command is reserved strictly for the SAS 8888ELP RAID controller at this
time. You must enable specific ports depending on how you intend to use the controller
Table 46: Display Time and Date on Controller
Convention MegaCli –AdpGetTime -aN
Description Displays the time and date on the controller. This command uses a 24-hour
format. For example, 7 p.m. would display as 19:00:00.
Table 47: Get Connector Mode
Convention MegaCli -AdpGetConnectorMode
-ConnectorN|-Connector0,1|-ConnectorAll
-aN|-a0,1,2|-aALL
Description Displays which ports are enabled (Internal/External, 0/1).
For example, if internal port 0 is active, internal ports 0-3 are active. If
external port 1 is active, external ports 4-7 are active.
Table 48: Set Connector Mode
Convention MegaCli -AdpSetConnectorMode
-Internal|-External|-Auto
-ConnectorN|-Connector0,1|-ConnectorAll
-aN|-a0,1,2|-aALL
Description Sets (enables) the connectors listed in the GetConnectorMode command.
For example, to enable internal ports 4-7 on controller 0, run the following
command:
MegaCli –AdpSetConnectorMode –Internal –Connector1
–a0
To Next Page
Loading...
