Page 277
MegaRAID SAS Software User Guide Chapter 8: Configuration
| Changing Power Settings
Figure 156: Set Adjustable Task Rates Menu
3. Enter changes, as needed, to the following task rates:
— Rebuild Rate
— Patrol Read
— Background Initialization (BGI) (for fast initialization)
— Check Consistency (for consistency checks).
—Reconstruction
Each task rate can be set from 0 to 100 percent. The higher the number, the faster
the activity runs in the background, possibly impacting other system tasks.
4. Click OK to accept the new task rates.
5. When the warning message appears, click OK to confirm that you want to change
the task rates.
8.5 Changing Power Settings The RAID controller includes Dimmer Switch™ technology that conserves energy by
placing certain unused drives into Power-Save mode. In Power-Save mode, the drives
use less energy, and the fan and the enclosure require less energy to cool and house
the drives, respectively. Also, this technology helps avoid application timeouts caused
by spin-up delays and drive wear caused by excessive spin-up/down cycles.
You can use the Power Settings field in MSM to choose whether to allow unconfigured
drives or hot spares to enter Power-Save mode.
NOTE: The Dimmer Switch technology is enabled by default.
To Next Page
Loading...
