Page 201
MegaRAID SAS Software User Guide Chapter 5: MegaRAID Command Tool
| Virtual Drive-Related Options
5.14.6 Schedule a Consistency Check Use the command in the following table to schedule a consistency check (CC) on the
virtual drives for the selected controller(s). There are options to set the mode, change
the CC start time, set the delay time and display of the CC info.
5.14.7 Manage a Background
Initialization
Use the command in the following table to enable, disable, or suspend background
initialization (BGI), as well as display initialization progress on the selected controller(s).
Table 77: Schedule Consistency Check
Convention MegaCli -AdpCcSched -Dsbl|-Info|{-ModeConc | -ModeSeq
[-ExcludeLD -LN|-L0,1,2] [-SetStartTime yyyymmdd hh ]
[-SetDelay val ] } -aN|-a0,1,2|-aALL
Description Schedules check consistency on the virtual drive of the selected adapter.
Dsbl: Disables a scheduled CC for the given adapter(s).
Info: Gets information about a scheduled CC for the given adapter(s).
ModeConc: The scheduled CC on all of the virtual drives runs concurrently
for the given adapter(s).
ModeSeq: The scheduled CC on all of the virtual drives runs sequentially for
the given adapter(s)
ExcludeLd: Specify the virtual drive numbers not included in the
scheduled CC. The new list will overwrite the existing list stored on the
controller. This is optional.
StartTime: Sets the next start time. The date is in the format of
yyyymmdd in decimal digits and followed by a decimal number for the hour
between 0 ~ 23 inclusively. This is optional.
SetDelay: Sets the execution delay between executions for the given
adapter(s). This is optional.
Values: The value is the length of delay in hours. A value of 0 means
continuous execution.
Table 78: Manage Background Initialization
Convention MegaCli –LDBI
-Enbl|-Dsbl|GetSetting|-ShowProg|-ProgDsply
–Lx|-L0,1,2|-Lall -aN|-a0,1,2|-aALL
Description Manages background initialization options. The following are the
background initialization settings you can select on a single controller,
multiple controllers, or all controllers:
-Enbl, -Dsbl: Enables or disables the background initialization on the
selected controller(s).
-ProgDsply: Displays an ongoing background initialization in a loop. This
function completes only when all background initialization processes
complete or you press a key to exit.
-ShowProg: Displays the current progress value.
- GetSetting: Displays current background initialization setting (Enabled
or Disabled).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
